Connect your controller

Connect your controller

When you start a mission, RAAD asks you to connect your controller first. It takes about a minute. Once it’s connected:

  • Photos upload while you fly, as the camera’s full-quality originals, so there’s nothing to upload after landing.
  • The mission page shows your aircraft: model, whether it’s flying, height and battery.
  • RAAD can start live video from the mission page when it’s needed.

You can always skip this step with I’ll upload after and upload from the SD card after landing, just like before.

What you need

  • DJI Pilot 2 on your controller: DJI RC Plus, DJI RC Plus 2, DJI RC Pro Enterprise or the Smart Controller Enterprise.
  • A DJI Enterprise aircraft that flies with Pilot 2: Matrice 4E/4T, Matrice 30/30T, Matrice 350 RTK, Matrice 300 RTK, or the Mavic 3 Enterprise, 3T or 3M.
  • Internet on the controller: Wi-Fi or a phone hotspot, or a 4G dongle (DJI Cellular).

Aircraft that fly with DJI Fly (Mini, Air, consumer Mavic) can’t connect this way. Upload the photos after landing.

Connect in three steps

  1. Tap Start Mission on the mission page. The first step shows a short address like pair.raad.com/k7m2qx.
  2. On the controller, open DJI Pilot 2, tap Cloud Service, then Open Platform.
  3. Enter the address and tap Connect.

The page on the controller shows your name and the mission, then ticks off each step. When it says Connected to RAAD. You can close this page., the start screen on the mission page says your controller is connected. Tap Continue to go to the pre-flight checks.

The address only works for this mission, and only for the first controller that opens it. If Pilot 2 restarts, open the same address again on the same controller.

While you fly

Fly the mission as you normally do. Each photo uploads as soon as it’s taken; the mission page counts them and shows whether they arrived at full quality.

Flight plans in Pilot 2

Once connected, the mission’s RAAD flight plans appear in Pilot 2’s Flight Route library, named like they are on the mission page. Open one, check it, and tap Start. Photos upload as you fly.

If you don’t see them, open the pairing address again. The page says how many (“2 RAAD flight plans are in Pilot’s Flight Route library”).

If something doesn’t work

  • “This code already connected controller …”: another controller opened the address first. Use that controller, or end the capture session on the mission page and start it again for a new address.
  • The Open Platform option isn’t there, or the page won’t load: sign out of FlightHub 2 in Pilot 2 (Pilot can’t be on FlightHub 2 and Open Platform at the same time), and check the controller is online.
  • “There’s no pairing with this code”: check the address on the mission page. Codes are six letters and numbers; capital letters don’t matter.
  • “Too many wrong codes”: wait ten minutes, then enter the address again.
  • Photos say “reduced”: in Pilot 2, set the photo upload to Original, not the preview.
  • No internet at the site: tap I’ll upload after and upload from the SD card when you’re back online.

Still stuck? Message RAAD from the mission page and tell us the address you entered and what the controller shows.